Dacor Oven Error U43
U20 over temp (upper/single) cook temp over 610f for 2 min 9-34 u43 relay board (upper/single) bad connection on s19 relay or bad relay board 9-40 l20 over temp (lower) cook temp over 610f for 2 min 9-34 l43 relay board (lower) bad connection on s19 relay or bad relay board 9-40 dacor tec-line: 800-353-2267 dacor discovery oven fault codes. Dacor oven error u43. We hope this troubleshooting guide below will help answer the most common problems in regards to your dacor oven or range if the problem persists, please do not hesitate to call us at (281) 758-9978 so we can further troubleshoot or arrange one of our specialized dacor technicians to resolve any problems dacor oven/range support and faqs.
dacor oven error u43
In december of 2008 we bought a dacor oven exactly 2 years later we started experiencing problems with the oven switching to broil mode regardless of what temperature we set the oven to this was. If alarm goes away verify the oven will complete a clean cycle without any type of failure. f3: shorted oven temperature sensor (rtd) check sensor harness and harness connection between oven sensor and oven control. replace oven temperature sensor (rtd) if wiring is ok. f4: open oven temperature sensor (rtd). This repair service is for a jenn-air and dacor oven control board, part number 62692. the most common problems associated with this control board are the oven not reaching temperature; the oven will not power off, and f1 or....
Comments
Post a Comment