Kitchenaid Error Code Replace Oven Ui
The ui is the code for a communication failure between eoc (electronic oven control) & esec system 1 test harness/connections p4 (eoc) & p11 (surface element control board) 2 if harness checks ok failure can be caused by faulty uib, surface element control board or eoc. Kitchenaid error code replace oven ui. F1-e3 – the size of the wiring harness cavity is different than the stored value – check to be sure that the jumpers in the harness are the same as the actual oven size.
kitchenaid error code replace oven ui
Kitchen aid appliance fault codes by steve ash kitchenaid oven/range/stove fault codes (including 2 and 4 digit codes) note: depending upon the brand of appliance, there can be many different names for the 'clock' component electronic range control, erc, electronic oven control, eoc, control board, and clock all refer to the same part. Kitchen aid range / stove / oven fault codes: failure code: fault code description: solution: 4 digit failure codes (for 2 digit codes see below) f1 - e0: eeprom communication error: 1. disconnect power for at least 30 seconds. 2. re-apply power and observe for at least one minute. 3. if code re-appears, replace control board (also called erc. Answer hello jeff, as per the tech sheet for the unit, you will need to replace the oven user interface wp9761566. you may also need the ribbon cable 9762921 for the wire style or w11209404 for the flat flex style cable. answered by appliancepartspros.com | wednesday, april 2, 2014.
Comments
Post a Comment